Need tile and grout cleaning in Brisbane?

Tiles look fantastic in the showroom, but once they’re in your home, contaminants begin to build up. These deposits accumulate in the grout and on the tile surfaces, and normal cleaning won’t remove them.

This happens because, under a microscope, you can see that tile surfaces are quite porous, especially in older homes. In the bathroom, soap leaves behind a coating of lime and chemicals, while in the kitchen, cooking fats and food stains form a hardened residue that ordinary cleaning can’t shift.

Why don’t domestic cleaners work? The real reason is simply safety – but even as the chemicals get stronger, the bacteria and deposits remain. Scientists think that bacteria adapt to the cleaners we use.

Nice ‘n Clean is different, not because we use harsh chemicals – we don’t. We use a high-pressure tile and grout cleaning Brisbane system that cleans out all the cracks, grooves and crevices that we can’t see – but gives a foothold to dirt and bacteria, in places too small for you to get your cleaners into.

When we clean normally, we can remove the top layer of grunge, but a layer remains, embedded in the porous material – and it immediately starts growing and expanding again.

HOW WE CLEAN TILES AND GROUT

Nice ‘n Clean uses a combination of specialist high-pressure tile and grout cleaning in Brisbane with relatively weak penetrative cleaning agents that get into all the pits, scratches and tiny cracks –this way all the contaminants are removed, and the tiles are back to clean, “like new” condition.

We don’t use scrubbers or brushes – that simply makes the problem worse, by increasing the damage to the tile surface. And we don’t “blast’ the tiles – this can damage grouting. Our cleaners have a special pressure technology that creates superfine jets of water which penetrate the cracks and grooves. We use this relatively gentle pressure to clean, rather than by chemicals

    Nice ‘n Clean can help get your home or office tiles looking brilliantly clean.

• Bathroom
• Kitchen
• Family room
• Patio
• Pool area
• Footpaths
• Driveway
• Walls

Our Process for Tile and Grout Cleaning Brisbane is as follows

Step 1. 

Investigate what type of tile and grout you have installed.

Knowing what tile and grout you have is important to achieve the best cleaning results. We can determine if you have sanded, unsanded or epoxy grout installed.   

Step 2. 

Check for any existing sealers that might have been previously applied to your tiles and grout.

It is important to know if any sealers were applied as this can determine the outcome of the tile and grout cleaning process. If we find a sealer has been applied then it may have to be removed which will greatly increase the cleaning results.   

Step 3. 

Apply our specialised cleaning solution and agitate if required.

We use advanced tile cleaning solutions that are sprayed onto the tile and grout surface to loosen trapped dirt, grease and stains. 

Step 4.

Rinse using high pressure is a self-contained extraction tool back to our truck-mounted machine outside.

This is the process that gives the best results and does not over wet the tiled floor. Over 1000 psi is used during the cleaning process.  

Step 5.

Place drying fans to speed dry. 

Once cleaned we will set up our air movers to completely dry your tiled floors.